Ways To Repair Roman Shades
Roman shades are cloth shades that hang with neat pleats when pulled up, and cover a window completely when dropped down. Roman shades, may fail to raise and lower for one or two reasons. The strings that work the shade may become dry-rotted and snap. In either case, it is a simple task to fix the shade, so that it works as good as new. Check shade for broken rings and snapped cords. Remove the unifier knob at the side where the gang of cords work the shade up and down by untying the strings and sliding the knob off. Remove the broken cords by untying the string at the bottom ring of each vertical line and pulling it out. Reinstate any broken rings at this time. Hand sew them in place where the old rings were, catching both lining and face fabric. Replace with new cording. Beginning at the bottom of the shade, tie the new cord to the ring, and slide the cord through each ring in the vertical line including the eyescrews that run horizontally across the shade header.
Each line of cord will go up to the header and then thread into each eyescrew across the header. Leave 36 inches, or so, of cord hanging free on the side where the gang of cords will be. Repeat the process at each vertical row of rings and cord as necessary. Gather the gang of cords together, trim the cords evenly, and slide the unifier knob on to the group. Knot the grouped cords, and pull the knob down over the knot. Rehang the roman shades. Adjust the tension on the cords by tugging the shade up and down a few times.roman shades pics, roman shades pictures, roman shades images, roman shades designs pictures, roman shades repair, .